MAINTENANCE AND CLEANING
To ensure an ideal reliability and a long working life of
the unit, we strongly recommend:
▪ Keep the unit and the surroundings clean.
▪ Be careful when filling the powder tank; do not let
particles enter the water tank, since the pump could be
damaged.
▪ Keep the powder and water nozzles clean. It will
prevent dirt gathering and the spindle from seizing up.
▪ Clean the unit thoroughly when changing the type of
powder, to prevent the pollution from the dirt that can
gather in the unit.
▪ The outer casing of the unit should be always cleaned
with a damp cloth. Do not use solvents.
▪ Watch the filling level of the tanks. Do not let the unit
work when the tanks are empty.
▪ Check the filter and the tanks periodically, as well as
the possible wear of the interior pieces and the
watertightness of the water tank.
▪ Use only original spare parts supplied by the
manufacturer.
REPLACING THE FILTER
The water tank has a filter to prevent particles entering
the tank. If it needs to be replaced, proceed as follows:
1. Remove the cap by pushing it with your finger
from inside the tank.
2. Unscrew the filter with a 13 mm tube spanner.
REPLACING THE SPINDLE
The spindle is a perishable element. Its duration depends
on the use of the machina. A spare spindle is included
with the machine. To replace it, proceed as following:
A
1. Loosen nut (A) rotating in the direction of the
arrow.
2. Remove the damaged spindle (B).
3. Place the new spindle and tighten the nut again.
PRECAUTIONS
▪ Before connecting the unit to the power source, make
sure the voltage is correct (grounded 230 V,
50/60 Hz).
▪ The cord may only be replaced by one with the same
characteristics as supplied by the manufacturer.
▪ Read these instructions carefully before operating the
unit. They contain very important information about
safety during the installation, operation and
maintenance of the unit.
▪ Keep these instructions for further consultation.
▪ Check out the state of the unit upon unpacking it.
▪ Before connecting the device, make sure the voltage
in the identification plate matches the power source to
be used. During the installation all the safety
requirements must be observed and the instructions of
the manufacturer followed.
▪ The manufacturer will not be liable for the damage
caused by an inappropriate grounding system.
▪ Damage caused by a faulty installation or a wrong use
of the unit is not covered by the warranty.
▪ When in doubt, do not start the unit. Contact the
supplier for questions or detailed information about
problems with the unit.
▪ Do not touch the unit or the power cord with wet
hands.
▪ Unplug the unit in case of storm and when you are not
going to use it for a long time.
English
13