Product Features; Package Contents; Installation And Setup - Tripp-Lite RELAYIOMINI El Manual Del Propietario

1. Introduction

1.1 Product Features

The RELAYIOMINI is a programmable UPS management device featuring:
• 3 relay output contacts
• Input signal to shutdown UPS
The RELAYIOMINI allows you to:
• Monitor UPS status and events
• Perform remote system shutdowns

1.2 Package Contents

This Package Contains:
• RELAYIOMINI
• Owner's Manual

2. Installation and Setup

2.1 System Requirements
The RELAYIOCARD supports various Tripp Lite SmartOnline™ UPS Systems (5-10kVA) equipped with the mini slot.
2.2 Installing
The RELAYIOMINI card will replace your UPS system's USB card to add dry contact support. To install the new card, simply unscrew the two screws
holding your current USB card in place and pull out the card. Disconnect the ribbon cable from the USB card. Then, attach the ribbon cable to the new
RELAYIOMINI card, slide the card into the same slot and re-attach the two screws you removed earlier.
Application Example
Using the default settings, set SW1 and SW2 to ON. Connect 12V DC supply between the common
and ground terminals. Connect equipment to R1~R3 terminals. Install a push button from the common
terminal to the input terminal. To remotely shut down the UPS, close this circuit for a minimum of 3
seconds.
2