Inserting / Replacing Batteries - PCE Stanley TLM 210 Manual De Empleo

User Manual
Version 1.0
English
Congratulations on your purchase of a Stanley TLM 210.
The safety instructions can be
found in a separate booklet, which
accompanies this user manual. The
safety instructions along with the
user manual should be read carefully before initial
operation.
Helpful Hint: The first and last page including the
pictures should be folded out and left open, whilst
reading through the manual. Letters and Numbers in
braces {} refer to the illustrations.
Content
Start-up
................................................................ 1
Operation
............................................................. 2
Measuring
............................................................ 3
Functions
............................................................. 3
Appendix
.............................................................. 4
Stanley TLM 210 1.0.0 gb
Start-up

Inserting / Replacing Batteries

See figure {C} - Push locking mechanism to the right
and push the cover of the battery compartment
downwards and open it. Place the batteries in the
compartment making sure they are correctly inserted.
Push the cover of the compartment back and let it
lock in place.
The battery symbol {B, 4} appears permanently
blinking in the display when the battery voltage is too
low. The batteries should be replaced as soon as
possible.
• Pay attention to correct polarity.
• Use alkaline batteries.
• Batteries should be removed if the device will not
be used for a long time (danger of corrosion).
When changing the batteries the settings and stack
content remain unchanged.
1
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
HR
H
RUS
CZ
Start-up
GR