BOND MANUFACTURING HYFP20018-10 El Manual Del Propietario página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FOR PROPANE GAS UNITS
*The gas pressure regulator provided with the propane fire bowl must be used.
*Do not attempt to disconnect the gas regulator or any gas fitting while your firebowl is in operation.
*A dented or rusty propane cylinder may be hazardous and should be checked by your gas supplier prior to use.
*Do not use a propane cylinder with a damaged valve and any other worn out parts.
*Transit and store the empty gas cylinders carefully and properly.
*If you see, smell or hear the hiss of escaping gas from the propane cylinder:
1. Disconnect propane gas cylinder
2. Do not attempt to correct the problem yourself.
3. Get to your gas supplier and/or the fire department for help.
*Any guard or other protective device removed for servicing this fire bowl must be replaced prior to operating this
appliance.
*The maximum supply pressure is the bottle pressure.
*This appliance is designed for use with a 16.40Z (1Lb) propane gas cylinder (disposable). The propane cylinder must be
constructed and marked in accordance with the specifications for Gas cylinders of the U.S. Department of Transportation
(DOT) or the National Standards of Canada, CAN/CSA-B339, cylinders, Spheres and Tubes for Transportation of
Dangerous Goods;and Commission,as applicable.
*Cylinders must be stored outdoors in well-ventilated area out of the reach of children.
*Disconnected cylinders must have valve caps tightly installed and must not be stored in a building or any other enclosed
area.
WARNING !
* Do not light or use gas unit if lava rocks are wet. Ensure lava rocks are completely dry before igniting as intense heat
could cause the rock to crack.
* Lava Rocks could hit somebody's face or eyes during initial start of this unit , so please keep away from the firebowl for
the first 20 minutes after it has been ignited.
*LP GAS WARNING: Do not exceed 1/4" depth of fire glass or small lava rock directly above burner holes. Applying too
much media may result in unburned gas pooling in firebowl or firepit. Ventilation is required to allow fresh air into
enclosure and any residual gas to escape.
Warranty and Installation Information:
The Bond warranty will be voided by, and Bond disclaims any responsibility for, the following actions:
► Modification of the firebowl and/or components including the gas valve assembly.
► Use of any component part not manufactured or approved by Bond.
► Use and Installation other than as instructed in this manual.
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

66038

Tabla de contenido