Danze DC026018 Guia De Inicio Rapido página 3

Water level
To raise
adjustment rod
water level
To lower
Refill tube
water level
Top
Tank lever
Water level
Float cup
Critical water
Flapper chain
level mark (C.L.)
must be 1" above
Valve
overflow pipe
Flush valve
Fill valve
body
Shank
Flapper
Washer
Lock nut
Threaded
shank
Cone washer
Coupling nut
Parts for water
(hand tight only)
connection
• Adjusting the tank lever:
When connecting the stainless steel chain to the tank lever arm, use the 1
or 2 hole closest to the tank lever (do not use the hole at the end of the
nd
arm) and insert the hook from the front to the back. This will reduce the
chance for the flapper to hang up.
Use 1 st and 2
3 ), and insert hook from
rd
front....
• Connecting the water supply line:
Metal/copper Vinyl/braided
tubing connector
Lock nut
Cone
washer
Coupling
nut
Water
shut-off
These parts must be used as illustrated to
insure water-tight connection. Use of existing
coupling nut or cone washer may result in
water leakage. Water supply tube or pipe must
extend at least 1/2" inside threaded shank of
valve (does not apply to flanged tubing).
Caution: Overtightening of lock nut or coupling
nut could result in breakage and potential
flooding.
3
Water level
To raise
adjustment rod
water level
To lower
water level
Top
Float cup
Critical water
level mark (C.L.)
must be 1" above
Valve
overflow pipe
Fill valve
body
Shank
Washer
Lock nut
Threaded
shank
Cone washer
Coupling nut
Parts for water
(hand tight only)
connection
Use 1 and 2 hole (not the
st nd
3 rd ), and insert hook from
nd hole (not the
front....
.... NOT the rear
Metal flanged Metal spiral
tubing tubing
Lock nut
Lock nut
Existing
washer
Coupling
nut
Existing
coupling
nut
Water Water
shut-off shut-off
Use existing Use existing spiral cone
coupling nut
washer. Fluidmaster
and washer. cone washer may not
seal completely on spiral
type supply line.
Caution: Do not use cone washer
with plastic supply line.
• Removing cap from pilot valve
Refill tube
Tank lever
Water level
Flapper chain
Flush valve
Flapper
st
• Removing/replacing the soft flapper
Lock nut
Symptom
Existing
No water flow when flushed
cone
washer
Water will not shut off
Coupling
nut
Water
shut-off
®
Lift the lever arm and rotate the cap counter-
clockwise approximately 1/8 turn. Lift cap as-
sembly off fill valve.
Lift arm
first
Replace cap by engaging lugs and rotating cap
1/8 turn clockwise.
Make certain that cap is turned into locked po-
sition. Valve may not turn on if the cap is not
fully turned to the locked position.
Disconnect chain hook from tank lever.
Remove soft silicone flapper from tabs on either
side of flush valve body.
Reverse steps to replace.
Action
Replace fill valve seal.
Flapper is hanging up. Place hook for flapper
in 1st or 2nd hole closest to the tank lever and
thread the hook from front to back.
Flapper is not sealing. Insure chain has some
slack when at rest and check the seal and rim
of the flush valve for damage or obstructions.
Insure water is not flowing into the overflow
tube. If so, lower water level by grasping the
top of water level adjustment rod and turning
to move float cup.