Safety Warnings; Assembly - Multitech MultiModem MT2834ZDXI Guía De Referencia Rápida

Safety Warnings

• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line
has been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electrical shock from lightning.
• Do not use a telephone in the vicinity of a gas leak.

Assembly

The only assembly required is to mount the feet on the bottom of the modem. (See
Figure 2-1) Simply peel the four self-adhesive plastic feet off the backing strip and
press them into the recesses on the bottom of the modem. Alternately, or
additionally, you can use the self-adhesive Velcro patches to mount the modem to a
vertical surface or to keep it from being dislodged on a horizontal surface.
If you use the Velcro patches, we recommend that you mount them where they will
not obscure the labels on the bottom of the modem. With mating pieces fastened
together, remove one protective strip from each set and press the Velcro into place
on the bottom of the modem. Then remove the remaining protective strips and,
positioning the modem carefully over the place where you want to mount it, press it
firmly against the surface.
The ZDX has no special placement restrictions, but we recommend that you place it
so that you can see the indicators on the front panel .
Chapter 2 - Installation and Connection
Figure 2-1. Mounting the feet
11