Multitech MultiModem MT2834ZDXI Guía De Referencia Rápida página 2

Tech
®
Systems
EMC, Safety and Terminal Directive Compliance
The CE mark is affixed to this Multi-Tech product to confirm compliance with the
following European Community Directives:
Council Directive 89/336/EEC of 3 May 1989 on the approximation of the laws of
Member States relating to electromagnetic compatibility;
and
Council Directive 73/23/EEC of 19 February 1973 on the harmonization of the laws
of Member States relating to electrical equipment designed for use within certain
voltage limits;
and
Council Directive 98/13/EC of 12 March 1998 on the approximation of the laws of
the Member States concerning telecommunications terminal and satellite earth
station equipment.
CTR21*
This equipment has been approved to Commission Decision "CTR21" for pan-
European single terminal connection to the Public Switched Telephone Network
(PSTN). However, due to differences between the individual PSTNs provided in
different countries, the approval does not, of itself, give an unconditional assurance
of successful operation on every PSTN network termination point.
In the event of problems, you should contact your equipment supplier in the first
instance.
International Modem Restrictions
Some dialing and answering defaults and restrictions may vary for international
modems. Changing settings may cause a modem to become non-compliant with
national telecom requirements in specific countries. Also note that some software
packages may have features or lack restrictions that may cause the modem to
become non-compliant.
European Low Voltage Directive
When correctly installed and maintained, the modem will present no hazard to the
user. When correctly installed the modem will be connected to the PSTN or a PW
and to a Data Terminal Equipment (DTE), whose modem connections comply with
ITU-T recommendation V.28. The DTE connections are therefore taken to be safe
voltages (less than ±30 volts).
Ports which are capable of connecting to other apparatus are defined as SELV. To
ensure conformity with EN41003, ensure that these ports are only connected to
ports of the same type on other apparatus.
*Applies only to the MT2834ZDXIe model.