auna 10032834 Manual De Instrucciones página 19

Using the Wireless VHF Microphone
The PA speaker comes with wireless microphones to get you started straight
out of the box.
1. Tune on the unit.
2. Unscrew the bottom of the microphone to access the battery enclosure.
Insert 2 AA batteries into the microphone. Take note the battery polarity
when inserting the batteries.
3. Replace the bottom microphone cover.
4. The wireless microphone will flash once and automatically pair with the
PA speaker, it is ready to use. If it does not flash , check that you have
inserted the batteries correctly or replace old batteries.
5. Adjust the volume of the microphone by turning the MIC VOL knob
located on top control panel
Notes: Please do not operate the microphone directly in front of the PA
speaker, please set the MIC VOL/ECHO at a lower level before turning
on the wireless microphone. Operating the microphone incorrectly will
cause a loud squealing noise. Please turn off the power switch when the
wireless microphone is not in use. This will save the battery.
Using the Wired Microphone
You can connect the wired microphone to this unit using the MIC INPUT
located on the top of control panel.
1. Turn off the unit.
2. Connect your wired microphone to the MIC INPUT located on top of the
control panel.
3. Adjust the microphone volume by tuning the MIC VOL/ECHO knobs
located on top control panel.
Notes: You can use the wired microphone and wireless microphone at
the same time.
EN
19