Pre-Operation Inspection; Set-Up And Operation - RIDGID CROSSCHEK Manual Del Operador

4. Open the pushrod shell on the CROSS-
CHEK unit and place the pushrod bulb,
(with pushrod attached), into the opening
making certain the grooves in the bulb
line up with the wire rope. (Figure 6)
Close the shell and tighten the two
screws.
Wire Rope
Figure 6 – Locate Pushrod Bulb In Shell
5. Slide the guide onto the camera head
making sure the wire rope is in the
grooves in the guide. Place the guide
onto the camera head so that approxi-
mately 1 / " (3.2mm) of the camera head is
8
exposed and tighten the clamp screw
(Figure 7 ).
Figure 7 – Installing Guide On Camera Head
6. Securely tie the rope to the spring clip
and attach to the wire rope loop as shown
in Figure 8 .
Wire Rope
Figure 8 – Attachment of Rope
Pre-Operation
Inspection
WARNING
Before each use, inspect your CROSS-
CHEK Inspection System and correct
any problems to reduce the risk of injury
and prevent tool damage.
CROSSCHEK ™ Inspection System
1. Clean any oil, grease or dirt from the
CROSSCHEK Inspection System includ-
ing the cone and adapter.
2. Check that the correct adapter is fitted for
the type of air hose available.
3. Inspect the CROSSCHEK Inspection
System for the following:
• Proper assembly, maintenance and
com pleteness.
• Any broken, worn, missing, misaligned
or binding parts.
• Presence and readability of the warning
label (Figure 9) .
• Any other condition which may prevent
safe and normal operation.
If any problems are found, do not use
the equipment until the problems have
been repaired.
Figure 9 – Warning Label
4. Inspect and maintain any other equip-
ment being used per its instructions to
make sure it is functioning properly.

Set-Up and Operation

WARNING
Set up and operate the CROSSCHEK In -
spection System and work area accord-
ing to these procedures to reduce the
risk of injury from electric shock, entan-
glement and other causes, and to pre-
vent tool damage.
3