Preparation; Assembly Or Installation Instructions - Style selections 2459VM-25-271 Manual De Instrucciones

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Installation Time: 20-30 minutes (24 hours for silicone caulk to dry).
Tools Required for Installation (not included): Phillips screwdriver, utility knife or scissors, silicone caulk,
power drill with drill bit
Helpful Tools (not included): Measuring tape, level
VANITY INSTALLATION INSTRUCTIONS
Note: Clean area where the vanity (A) will be
permanently located prior to beginning installation,
ensuring the vanity (A) will not interfere with any
water supply and drain lines once mounted.
1. With the help of another adult, carefully place
vanity (A) against the wall in its final location.
From inside vanity (A), drill hole through vanity
mounting area and into wall studs. Using
mounting hardware (not included) appropriate
for your installation site, secure vanity (A) to
wall stud. If possible, secure vanity (A) to
two wall studs for increased stability.
Note: Use preassembled levelers on legs of
vanity (A) to level the item. Twisting the
levelers counterclockwise will increase the
height of vanity (A), twisting them clockwise
will decrease it.
WARNING
Vanity (A) MUST be secured to wall.
1
4
1 2
A