Kohler K-2362 Guia De Instalacion página 5

Install the Lavatory (cont.)
Thread the hanger bolts into the finished wall until each hanger
bolt is exposed 1-1/2" (3.8 cm) between the cap nut and the
finished wall.
Remove the cap nuts.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
Move the pedestal back into position.
Place the lavatory over the hanger bolts. Ensure the lavatory is
flush against the pedestal and the finished wall.
Remove the lavatory from the pedestal. Set the lavatory aside.
CAUTION: Risk of product damage. Do not overtighten the
washer and lag bolt. Overtightening may damage the product.
Thread a washer and lag bolt through the hole in the pedestal
and into the floor until the washer contacts the pedestal. Do not
overtighten.
Carefully set the lavatory on the pedestal so the hanger bolts
extend through the lavatory anchoring holes.
Verify the installation is level and properly positioned.
CAUTION: Risk of product damage. Do not overtighten the cap
nuts. Overtightening may damage the product.
Thread a cap nut and washer over each hanger bolt until the
washer and the cap nut are tight against the lavatory.
Secure the P-trap to the drain.
Connect the water supply lines to the faucet according to the
manufacturer's instructions.
Kohler Co. 5 1020683-2-E