BOND MANUFACTURING BH6101-10 Manual Del Usuario página 4

SAFETY INFORMATION
• Inspect the burner before each use of this fireplace. If there is evidence of damage, the burner must be replaced
prior to use of this fireplace.
• Inspect the hose before each use of this fireplace. If the hose shows signs of cracks, abrasion,
cuts or damage, do not use this fireplace. Fix the hose as required before using appliace.
• Remove the hose out of pathways where it may be tripped over or subject to accidental damage.
• Children and adults should be alerted to the hazards of high surfact temperatures and should
stay away to avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the area of this appliance.
• The LP gas supply tank must be constructed and marked in accordance with the specifications for
LP gas tanks of the U.S. Department of Transportation (DOT) or the National Standard of Canada CAN/CSA-B339,
LP gas tanks, spheres and tubes for the Transportation of Dangerous Goods; and Commission.
• The LP gas tank must have a listed overfilling prevention device (OPD) and a QCCI or Type I,
(CGA810) LP gas tank connection.
Caution:
Only use the pressure regulator and hose assembly supplied with this fire table. Replacment pressure
regulator and hose assemblies must be specified or supplied by BOND MANU-FACTURING CO.
Inspect the burner before each use of the appliance. If the burner shows signs of damage of any kind, do not
operate the appliance. Fix or replace the burner as required before using the appliance. For assistance with
repair or replacement of the burner, call Bond Manufacturing at 1-866-771-2663. Use only replacement parts
from the manufacturer.
Caution: This heating item should not be used on plastic composite or artifcial wood decks.
WARNING ! WARNING !
* Do not light or use gas unit if lava rocks are wet. Ensure lava rocks are completely dry before igniting as intense heat could
cause the rock to crack.
* Lava Rocks could hit someone's face or eyes during initial start of this unit , so please keep away from the fireplace for the
first 20 minutes after it has been ignited.
Warranty and Installation Information:
The Bond warranty will be voided by, and Bond disclaims any responsibility for, the following actions:
► Modification of the fire table and/or components including the gas valve assembly.
► Use of any component part not manufactured or approved by Bond.
► Use and installation other than as instructed in this manual.