BOND MANUFACTURING BH6101-10 Manual Del Usuario página 6

ASSEMBLY INSTRUCTIONS
* If you have opened the carton and removed all packages, please disregard STEP 1 and 2. See STEP 3 directly.
STEP 1.
(1) Open the carton and turn it upside down, make sure the 4 pieces of
the carton being open up as shown on right.
(2) Lift off the carton carefully and be wary of the accessories inside falling away.
(3) Take all the packing materials away except for the polyfoam
rounding the top of the fireplace.
See Figure STEP 1.
Take away the boxes containing lava rocks.
STEP 2
(1) Turn the fireplace heads up on a flat ground.
(2) Cut off the binding tape on the polyfoam and remove all the
polyfoam rounding the top of the fireplace.
(3) Cut off the tie fastened the regulator at the metal stand and set it free for
installation to Pronane Tank.
See Figure STEP 2
STEP 3
(1) Attach the chimney to the body using 4pcs M6 x 15 screws
amd 4pcs M6 washers.See Figure STEP 3.
STEP 4
1) Check each part before using the product. Make sure the gas
supply system is turned "OFF" before assembling. See Figure 1.
2) Locate the battery, remove the plastic cover first. Unscrew the
rubber cap of the Electric Ignitor; place a AAA battery into the
battery case. Make sure the positive pole ("+") is towards the cap.
Screw the cap back to the battery case tightly. See Figure 2 .
3) Place the lava rocks evenly in the fire bowl of the
fireplace. See Figure 3.
4) Put the gas tank in the metal stand. Make sure the gas tank sits on
the metal stand completely. Turn the wing screw on the outer part of
metal stand clockwise to secure the gas tank tightly.
See Figure 4 & 5 .
See "LP (Liquid Propane) gas supply
connection" for tank connection .
* Please keep these owner's manual for future reference.
6