Package Contents; Initial Operation - Schwaiger OLS-105-M Manual De Instrucciones

Important safety instructions on the integrated battery
• The battery is permanently installed in the casing. It cannot be replaced.
• Batteries can be lethal if swallowed. Keep batteries and remote control out of reach of children and animals. If a battery
is swallowed, seek medical attention immediately.
• If a battery has leaked, avoid contact of skin, eyes and mucous membranes with the battery acid. In case of contact
with battery acid, immediately rinse the affected areas with plenty of clean water and consult a doctor.
• Never throw the product into a fire, as the battery may explode or cause a flame hazard.
• Recharge the device battery on a regular basis, even if you do not use it for a longer period of time. Otherwise, it may
get deeply discharged and become permanently unfit for use.
• The batteries do not need to be discharged before being recharged.
• Place the product on a surface which is not sensitive to heat when recharging. It is normal for the product to become
slightly warm when recharging. Ensure sufficient ventilation.
• Dead or damaged batteries may cause skin irritation, so use suitable protective gloves when handling them.
• Leaking battery fluids are highly corrosive, and may seriously damage objects or surfaces they come into contact with.
• Do not expose the product to direct sunlight or heat. Ambient temperatures should not fall below -5 degrees or exceed
+35 degrees.

Package Contents

• Battery-operated multipurpose light
• Micro-USB charger cable
• Remote control
• Operating and safety instructions
Product details
1 Speaker
2 Lamp base: On/Off switch
3 Lamp base: Micro USB charging port
4 Lamp

Initial operation

NOTE
It is recommended to fully charge the integrated battery before using the product for the first time. Charging takes about
four to eight hours.
Process:
Only use a USB charger with max. 5V output voltage.
• Insert the Micro-USB plug into the charging socket on the bottom of the lamp.
• Connect the USB cable to a 5V power source such as a computer, laptop, power bank or USB adapter.
• A red light will illuminate when the product is charging. The light will turn off when the product is fully charged.
• Disconnect the device from the power supply.
NOTE
Charge the device regularly. Make sure that you keep the battery charged to 50% when not in use for a long time. The
device will also discharge when not in use.
Operating Modes & Functions
Power ON/OFF
Press and hold the On/Off switch for 1 second. To turn the device off, press and hold the On/Off switch again for 1 second.
You can also use the On/Off button on the remote control.
Changing light modes
The device has four different light modes and can switch between different colours.
• Briefly press the On/Off switch to switch between the different light modes.
7
USER GUIDE