NORTH STATES 8620 Instrucciones página 3

INSTALLATION AND OPERATING INSTRUCTIONS
PRESSURE MOUNTING
Pressure Mounted maximum opening size 40" (if opening is greater than 40" use
Door or Rail sockets).
STEP 1
Place gate on floor with handle on the opposite side of area accessible to the child,
expand the gate so that all four bumpers are in contact with sides of the opening.
STEP 2
Rotate locking handle and insert handle tab into the slot that gives you enough tension to secure the gate.
STEP 3
To release locking handle press down on it lightly, twist it outwards, and pull gently away from the gate.
PRESSURE MOUNTED USING DOOR SOCKETS
Always use tape pads when using mounting sockets.
Note: Foam tape may leave a foam residue or damage some wall surfaces when removed. Screws,
in addition to tape, may be used for added security. Four longer screws are provided in hardware
package.
STEP 1
Place tape pads in recessed area of door sockets.
STEP 2
Remove protective cover sheet from one of the door sockets and with "U" upright, place on a flat,
even surface 2 ¾" and not more than 4" above the floor. Do the same on the opposite side. Mount the
remaining two door sockets 20" (measured from the bottom of the sockets) above the bottom sockets 1 & 2.
STEP 3
Mount the gate by aligning the four bumpers in the door sockets and rotating the handle and
locking it into the slot that gives you enough tension to secure the gate. See Figure 2.
STEP 4
To release the locking handle, press down on it lightly, twist it outwards, and pull gently away
from the gate.
PRESSURE MOUNTED WITH IRON RAILINGS
If your opening has iron railings on both sides you will need to use all four rail sockets. If one side is a
wall, you will need two rail sockets and two door sockets.
Note: Gate must me mounted to a corner post of the railing and railing must be securely fastened to
the floor.
STEP 1
Measure size of railing post. Rail sockets will fit 1", 1
right to fit your rail socket.
Continue by following steps 1-4 under Pressure Mounted Using Door Sockets.
(On Openings over 40")
Figure 4
/ " and 1 ¼" rail posts. Refer to image at
1
8
Figure 1
Figure 5
Figure 6
Figure 7
Page 3
Figure 2
Figure 3