1. INTRODUCTION
Congratulations and thank you for purchasing the new Neos IV
ensemble.
This column has been designed, manufactured and checked by our
team of technical staff. The column must be installed in accordance
with current standards and by a qualifyed fitter following the cor-
responding instructions.
This handbook contains the necessary instructions to ensure that
the Neos IV is installed correctly.
Breach of this condition renders the product warranty null and
void.
2. DESCRIPTION Of THE EQUIPMENT
The Neos IV ensemble is supplied in different packages. Please
check that all parts have been received and are in perfect condition
before beginning the installation.
Neos IV: 1 unit.
(Depending on the version: Single-level tap or thermostatic)
Shower Upper
fittings Box
x6
x1
3. PRELIMINARIES
Check the space available before beginning the installation of the
Neos IV ensemble.
The water outlets from the plumbing system must be at the intended
location.
The minimum height for installing the column is 2300mm.
Concerning the water pressure and temperature:
Dynamic pressures lower than 2 bars will prevent the proper adjust-
ment of the taps.
For pressures over 5 bars, install a pressure reducer in both the
cold and hot water supplies.
Accumulator tanks:
For accumulator tanks below 100 litres it is recommended to
increase the thermostat to the highest possible value, as the hot
water hydro-massage will otherwise last only a few minutes. In the
interests of safety this value must not exceed 60º C.
6
x1
x5
x2
x1
x8
x2