Setting Up A Digital Tuner; With This Antenna - Philips SDV2750/27 Manual De Instrucciones

4.2 For UHF reception
Turn your TV to the desired channel.
1
Turn on the amplifier by rotating the UHF
2
gain control knob towards the max position
until reception is improved.
D Note
You may need to turn the gain control down to
a lower setting for best reception.
Position the UHF reflector until you obtain
3
the best reception by rotating it side to side
and up and down.
4.3 Setting up a digital tuner
with this antenna
Digital TV tuners require you to program the
tuner with the available channels in your area.
Generally this automatic process is part of the
set-up of the tuner. However, if you do not have
the antenna set up properly you may find that
the tuner receives no viewable channels.
If you have access to a rooftop antenna or
another antenna which is currently connected
to a digital tuner you may use the antenna
to program the tuner. The channels will be
memorized in the tuner - which will make
aligning this antenna easier.
Another method is to connect the antenna
directly to your TV (not using the tuner) and
tune to analog channels to find best location of
the antenna, then re-connect the digital tuner
– if you have adequate signal level you should be
able to program the tuner.
6
2750_27.indb 6
9
10
9
10
5/7/08 10:32:48 AM