Troubleshooting - GYS CONVERGYS 150 Guia De Inicio Rapido

Translation of the original instructions
OPERATION
150 W MODEL:
1) Connect the Convergys to the cigarette lighter socket of a vehicle.
2) Switch the inverter ON and connect your equipment to the Convergys (230V or USB 5V).
3) After use, unplug your equipment and then switch OFF the Convergys and disconnect it from the cigarette lighter.
TECHNOLOGY DATA
MODEL
Input voltage
Output voltage
USB Output
Continuous power
Peak power
Output frequency
Output waveform
Max Output efficiency
12V input, No load current
Low voltage protection
Over voltage protection
Overload shutdown
Operation temperature

TROUBLESHOOTING

SYMPTOM
No voltage output
The device turns ON and
OFF intermittently
The inverter turns OFF
when a connected device
is switched ON
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
CONVERGYS 150
CAUSES
Bad connection
Weak battery
Thermal overload
Fuse failure (in the inverter or vehicle)
The direct load is too high.
The starting current is too high.
Convergys 150
DC 12 V
AC 220 V - AC 240 V
DC 5V (2100 mA)
150 W
300 W
50 +/- 3 Hz
Modified sine wave
85%
< 0.45 A
DC 10.2-10.8 V
DC 15-16 V
18A--22 A
5° C – 35°C
REMEDIES
Check the cigarette lighter plug and cable
connections
Check the vehicle battery
Start the engine of the vehicle if necessary
Stop the device. Leave the inverter to cool
ensuring adequate ventilation.
Check and replace fuse
Reduce the load
Check if the maximum power of the inver-
ter is suitable for the required power of the
device
EN
9 9