Important Information; Battery Installation; Battery Safety - THINK GIZMOS TG642 RACING CAR KIT Manual De Usuario

1. IMPORTANT INFORMATION

1.1 Battery Installation

Drill Battery Information:
A small crosshead screwdriver (Phillips) is required to remove the battery compartment
●
on the Drill. Insert 2x AA batteries (supplied) into the battery compartment observing the
correct polarity as indicated.
Re-fit the battery cover and secure with the screw.
●
Engine Battery Information:
● The Construction Car will arrive partly constructed in the packaging. To reach the battery
compartment on the motor you must dismantle the car.
● The batteries are already inserted into the motor. Simply remove the plastic tab and switch
it on then it will be ready to run.
(Warning - Remove the batteries if the Car is not going to be used for a long time.)

1.2 Battery Safety

1. Please do not try and recharge batteries always replace them.
2. Incorrect use of batteries may cause damage, so please pay attention to the following:
● Do not install batteries with opposite polarity.
● When not in use, please switch to 'OFF' position and if the Car is not going to be used for
a long time, please remove the batteries to avoid corrosion.
● Do not mix old and new batteries.
● Please replace exhausted batteries as soon as possible.
● Keep batteries away from children.
● Do not place batteries near fires or expose them to strong sunlight or damp conditions.
Please dispose of batteries carefully.
●
3. Careful with small parts, do not eat.
4. Do not place near fire, high temperature or damp conditions.
3