Safety Information - EVGA BA Serie Manual De Instrucciones

450W / 500W / 600W Bronze
Power Supply User Manual
Introduction: Premium Power
The EVGA BA power supplies offer an affordable and stylish
alternative for those looking to build a safe and efficient system.
80PLUS Certified Bronze means the BA power supplies are at
®
least 82% efficient under a standard load, and are built to maintain
low electrical ripple and noise during operation. With increased
voltage stability on the 3.3V and 5V rails, Active PFC, and a full
suite of protections, the EVGA BA power supplies should be at
the top of your list to power your next system build.

Safety Information

WARNING: This unit has no user-serviceable parts inside.
Opening the casing presents a risk of electrocution and will void
the products warranty. EVGA will not be responsible for any
result of improper use, including but not limited to, any use of the
product's outside of its intended purpose or use inconsistent with
the warranty terms available online. (Warranty information is
available at www.evga.com/support/warranty
available at www.evga.com/manuals).
Features
STABLE POWER
The 450 BA/500 BA/600 BA has outstanding electrical performance with
and
ultra stable voltage extremely clean power
help you achieve the highest possible overclock (optional) and
provide the most stable and reliable power to all components.
The 450 BA/500 BA/600 BA also provides
efficiency and is
(220VAC~240VAC)
TOP QUALITY PROTECTIONS
The 450 BA/500 BA/600 BA comes equipped with the most
comprehensive protection set possible, including Over Voltage
Protection (OVP), Under Voltage Protection (UVP), Over Power
Protection (OPP), Short Circuit Protection (SCP), Over Temperature
Protection (OTP), and Over Current Protection (OCP). This product
is also covered by a
3-year warranty
service and support.
Installation
1. Remove the power supply from its packaging.
English
and this manual is
output. This can
up to 85% (115VAC) / 85%
certified.
80 PLUS BRONZE
®
and EVGA's legendary customer
2. Use the screws provided with your case to install the power
supply into your computer.
the power supply with the fan facing down. However, if your
case places the power supply at the bottom of the case and
there are no ventilation holes available, it may be best to install
the power supply with the fan facing up for greater efficiency
and reliability.
3. Connect the 20+4-pin ATX cable to the motherboard.
4. Connect the 4+4-pin EPS12V cable to the motherboard.
5. Connect the 6/6+2-pin PCI-E cables to your graphic card(s).
Do not attempt to plug an 8-pin PCI-E cable into a 6-pin
NOTE:
connector without first detaching the two extra pins.
6. Connect SATA power cables to all data drives or optical drives.
(hard drives, solid state drives, optical drives)
7. Connect the peripheral "Molex" 4-pin connectors for fans,
pumps, legacy components and other devices/adapters.
8. Connect the AC power cord to your power supply and to the wall.
Check all connections to assure a solid connection and turn the
power switch on the power supply to the ON position.
It is recommended to install
NOTE: