FAR LEANA CI Manual De Instrucciones página 66

ENGLISH
6. When the heating indicator goes out, this
indicates that the chosen temperature has
been reached and the steam is ready to start
ironing.
Note: While ironing, the heating indicator will turn
on and off occasionally. This indicates when the iron
is heating to reach the chosen temperature.
Note: The appliance may occasionally produce
a pumping sound during steam ironing. This is
normal. This sound indicates that the water is being
pumped into the plate.
7. Press the steam trigger to release steam
from the iron. During use, to eliminate very
stubborn creases, continuously press the
steam trigger twice, you can then iron the
fabric with short bursts of steam.
Warning:
1) Never touch the hot plate until it has cooled
down!
2) Never direct steam towards a person!
3) The supply tube may become hot during
prolonged ironing.
4) The appliance cannot release steam if an
appropriate plate temperature has not been
reached or if the temperature setting was not set
GB-12
correctly. (No steam is produced in temperature
settings 1 and 2.)
5) If the pump becomes noisier, this probably
means water needs to be added to the tank.
8. After ironing, you can place the iron on the
heat insulation pad. Unplug the power cable
of the appliance from the mains socket. But
the plate is still hot, never touch it with your
hands, place it on the heat insulation pad
until it has completely cooled.
9. You can place the iron upright and press the
steam trigger to iron curtains or hanging
clothes (jackets, suits, coats).
NOTE: Do not use the device continuously for 1
hour.
10. Your iron is equipped with a drip stop
function. When the temperature is below the
chosen temperature, the iron automatically
stops projecting steam (whether you press the
steam trigger or not) to prevent drip of water
coming out of the plate.
ENGLISH
GB-13