Beacon Lighting LUCCI Manual Del Usuario página 10

Airfusion Radar Installation Instructions
INSTALLING THE TRANSMITTER HOLDER
Remove the cover (A) from the holder (B). Install the holder (B)
with the two screws provided (C).
Replace the cover (A) into holder (B). Fig. 14
WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet.
If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimeters
is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE:
Please check that all screws which fix the mounting bracket are secure.
NOTE: This fan has been precision balanced at the factory and will not need to be balanced again.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-hour "breaking-in" period, most noises associated with a new
fan disappear during this time. All electric motors are audible to some extent. Please note that this is not a
product fault, and as such is not covered under warranty.
CARE AND CLEANING:
⚫
Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth
to avoid scratching the paint finish. Please turn off electricity power when you do so.
⚫
Do not immerse your ceiling fan in the water. It could damage the motor or the blades and create the
possibility of an electrical shock.
⚫
Ensure that the fitting does not come in contact with any organic solvents or cleaners.
⚫
To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.
⚫
The motor has a permanently lubricated ball bearing so there is no need to oil.
NOTE: Always turn OFF the power at the mains switch before attempting to clean your fan.
9 | P a g e
Fig. 14
AFTER INSTALLATION
C T