Freud RTP1000 Instrucciones De Instalación página 2

RTP1000 Set Up Instructions
WARNING: FAILURE TO HEED THESE WARNINGS COULD LEAD TO SERIOUS BODILY INJURY OR DEATH.
• Always wear eye protection complying with current ANSI standard Z87.1.
• Always disconnect power from the router before inserting bits or making any changes.
• Always when setting up and collapsing the table, keep fingers away from "pinch points" at folding locations to avoid injury.
• Always set table base on level ground, table, or floor surface.
• Table base must be securely fastened to the table top.
• Ensure that the assembled router table will not slide, roll or topple during use.
• Before each use, ensure that the router table, router table base, router fence, router and router bit are all free from damage.
• Do not use if damage is noticed or suspected.
• Do not use a router that exceeds 3
• Keep guards in place. Do not use if guards are damaged or have been removed.
• Read and obey all warnings and instructions contained in router's operator's manual and the router bit's packaging. If you do
not have the operator's manuals, obtain them from the manufacturers before using.
• Before each use check that router bit is sharp. Never use a router bit that is dull.
• Keep body and clothing clear of spinning bit.
• Before each use ensure that at least 80% of the router bit shank is inserted in the collet of the router. Do not,
however, ''bottom-out'' the bit in the collet. The end of the bit shank should be about 1/8 inch from the bottom of the collet.
• Before each use ensure that the collet of the router has been tightened.
• Use router fence whenever possible.
• Use multiple passes when removing large quantities of material.
• Never use a router bit on a router that will exceed maximum recommended RPM of bit.
Please keep these warnings and instructions in a safe place for future reference.
1
Open the stand by pulling the top of the inside leg
forward. Beware of "pinch points" at folding
locations. Keep fingers away from "pinch points".
Note: At this time you may choose to mount your router to the insert plate.
1) Remove the plastic base from the router and align it with the closest corresponding ring on the bottom of the insert plate.
2) Mark the locations of the mounting holes on your insert plate using your routers' base plate as a guide.
(Before you drill any holes, make sure the router is positioned in the manner that you prefer).
3) Drill holes through the insert plate using a drill bit that corresponds with the mounting screws supplied with your router.
4) On the top of the insert plate, countersink each hole with a drill bit that corresponds to the head of the
5) Attach the router to the insert plate and ensure that the router mounting screws are level with or slightly below the
All manuals and user guides at all-guides.com
1
/ HP with this router table system.
2
Maximum Recommended Router Speeds For Freud Router Bits
Diameter
Up to 1''
1
1" to 1- / ''
4
1 1
1- / " to 2- / ''
4 4
1 1
2- / " to 3- / ''
4 2
mounting screws of your router.
surface of the insert.
To learn more about Freud
Max. Speed
24,000 RPM
l8,000 RPM
I6,000 RPM
I2,000 RPM
2
® products visit us at www.freudtools.com
2
Install the (8) included #10 socket flat head
leveling screws in the threaded holes shown
above.