Freud RTP1000 Instrucciones De Instalación página 6

Using The Fence In Offset Position
The infeed and outfeed fences of the SH-5 are independently adjustable and can be used with a straight or flush trim bit for
applications such as "Jointing" to true the edge of a board.
CAUTION:
Turn off the router and disconnect from power before inserting the bit or making any adjustments. Consult the
router's operator's manual for instructions on installing a router bit.
A
Insert a straight or flush trim bit. (Make sure that the bit is longer/taller than the material to be jointed.
B
If using a flush trim bit with a bearing, align the bearing flush with the fence face. If using a flush trim bit with no bearing,
align the carbide edge flush with the fence face.
C
Using the micrometer knob on the infeed fence, rotate the knob clockwise, one complete rotation for .050" depth of cut
(approx 1/16"-1/8"). Once you have made your adjustments tighten the locking screws to secure your settings.
D
Direction of feed when facing the fence is from right to left. If the chip guard was removed while making any adjustments,
be sure to properly install the chip guard before operating the table. Adjust the chip guard horizontally so that the entire bit
is covered and vertically so that it is as close to the material as possible without contacting the router bit or the material to
be routed.
All manuals and user guides at all-guides.com
Micrometer Knob
(infeed side)
To learn more about Freud ® products visit us at www.freudtools.com
6
Locking Screws