Danze Cirtangular DC023330 Instrucciones Para La Instalación página 4


2. Install new wax ring (not included) on the bot-
tom of the toilet bowl (A) making sure not to
cover the toilet bowl outlet. (Alternate Method:
The wax ring may also be placed onto the floor
flange.)
3. Install the new floor mounting bolts (not in-
cluded) upright in the slots of the floor flange.
Place the toilet bowl (A) over the floor flange/
waste line opening by aligning the floor mount-
ing bolts in the toilet floor bolt holes. Press
down firmly and twist toilet bowl (A) slightly to
compress wax ring and assure a seal between
the toilet bowl (A) and floor.
4. Place one floor mounting bolt washer (not
included) over each floor mounting bolt and as-
semble the floor mounting bolt nut to the floor
mounting bolt. Tighten floor mounting bolt
nut carefully until the floor mounting bolt nut
is just snug.
5. Install the ceramic floor bolt cover plates (O)
(included) by firmly pressing the ceramic floor
bolt cover plates (O) into the recesses in the side
wall of the toilet bowl (A). (Six additional strips
of hook and loop tape (P) are provided should
replacements be needed in the future.)
6. Before assembling toilet tank (B) to toilet
bowl (A) check tightness of lock nuts on both
flush valve and fill valve.
7. Assemble toilet tank mounting bolts (C) in toi-
let tank (B) with rubber toilet tank bolt washers
(D) and plastic wing nuts (E). Plastic wing nuts
(E) should be tightened by hand sufficiently to
compress rubber toilet tank bolt washers (D) and
insure water seal.
8. Assemble toilet tank to bowl gasket (F) to
flush valve shank so that lock nut is enclosed in
recess, making sure that the entire surface of the
toilet tank to bowl gasket (F) is in contact with
the toilet tank bottom.
9. Place two channel pads (G) onto the posts on
back of toilet bowl ledge to prevent china-to-
china contact.
10. Place toilet tank assembly in position. Tight-
en the plastic wing nuts (E) sufficiently by hand
to prevent rocking. Since the toilet tank mount-
ing bolts (C) are already sealed, the toilet tank
(B) can be leveled by the relative amount that
each plastic wing nut (E) is pulled down on the
three points of contact- toilet tank to bowl gas-
ket (F) and two channel pads (G).
11. The fill valve coupling nut (H) is provided to
connect the water supply line to the fill valve.
Do not use pipe dope! Hand tightens only!
Over tightening may split the fill valve and will
void the warranty.