Publicidad
Idiomas disponibles
Idiomas disponibles
6x6 SHADOWBOX PRIVACY PANEL INSTALLATION INSTRUCTIONS, CONTINUED
Check measurements of fence. Actual size of panel varies by
description and model number (fig. 4). Use a string line to
ensure all post holes are in line and verify spacing between
holes. Double-check all measurements.
Installing brackets to posts
• Prepare the pre-assembled fence panels by sliding the mount-
ing brackets into the rails with the open space facing out toward
the picket (fig. 5).
• Slide the bracket fully in the rail. Later, you will be able to slide
the bracket outward to get a perfect fit if your post opening is
slightly wider than the suggested dimension of 67".
Setting and installing posts and panels
• Starting at a corner, mix concrete in the first hole per the
instructions on the bag. Mix thoroughly and install the post into
the hole and tap the post to the proper depth. Measure to be
sure you can install the finished panel to the post with approxi-
mately a 2" gap from the ground to the bottom of the panel.
You may also need to leave a space from the highest point of
the panel to the top of the post (fig. 6). The spacing allows the
cap to be installed on top of the post without interference with
the top rail.
• Install the next post as described above, paying careful
attention to the spacing between posts. It is important to
determine the height requirement for mounting the next
panels, as you may need to leave more post above the
ground to accommodate its mounting height (especially
if you are installing the fence on an uneven landscape).
• Slide the panel between posts and position to the desired
height. Use wooden blocks or shims to obtain the proper
spacing from the ground. Using the supplied screws
(four per bracket), attach the panel to the posts. Be sure
to center the fence brackets on the post.
• Use a level to ensure the fence is plumb and the posts are
square with the ground. Brace the panel and post to hold the
position as the concrete sets (per the time frame established
in the manufacturer's instructions). Continue setting posts and
installing panels to complete the project. Once posts are set,
finish panel installation by using the provided screws to secure
the fence bracket to the panel.
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR
USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE
CONSTRUCTION OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT,
INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT
PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
3' x 8' or 4' x 8' Panels
• Install a post cap on each post using a clear PVC cement
©2015 Universal Forest Products, Inc. All rights reserved.
68956 U.S. Hwy 131, White Pigeon, MI 49099 616.365.4201 7953_12/15
www.ufpi.com
Center to
Description
Center of Post
6' x 6' Panels
72"
96"
6' Gates
47-3/4"
3' or 4' Gates
46-3/4"
2 "
or an exterior adhesive.
PrivacyPanelFig6.ai
Inside Post to
Highest Point of
Post Dimension
Panel to Top of Post
67"
1-1/2"
92"
0" - even with post
42-3/4"
1-1/2"
42-3/4"
0" - even with post
fig. 4
fig. 5
fig. 6
Publicidad
