Safety Advice; Technical Data; Ambient Temperature - Resol SP10 Instrucciones De Montaje Y Conexión

RESOL SP10
Overvoltage protection device

Safety advice

Please pay attention to the following
safety advice in order to avoid danger
and damage to people and property.
Appropriate usage
This product is an overvoltage pro-
tection device used for protecting
the susceptible temperature sensors
in or at the collector against induced
overvoltages in compliance with the
technical data specified in these in-
structions.
Improper use excludes all liability
claims

Technical data

Material:
Lower part of housing:
Karilen E42D-H201
Upper part of housing: Luran S757R
Protection type: IP 65
Dimensions: 111 x 68 x 40 mm
(4.37 x 2.68 x 1.57")

Ambient temperature:

-25 ... +70 °C (-13 ... 158 °F)
Order note
RESOL SP10 Article-No.: 18011070
6
|
Table of contents
Safety advice ............................................................................................. 6
Technical data ........................................................................................... 6
1. Mounting ............................................................................................. 7
2. Electrical connection.......................................................................... 8
Imprint ................................................................................................... 8
Subject to change. Errors excepted.
The RESOL overvoltage protection device SP10 should be used in order to pro-
tect the susceptible temperature sensors in or at the collector against induced
overvoltages.
In the case of local thunderstorms, voltage peaks which could destroy the sensor
can be induced in the sensor cable. The protector diodes in the SP10 limit these
overvoltages to a value harmless to the sensor.
The best way to protect the sensor is to install this connecting box close to
the sensor. Because of the weather conditions, the SP10 is designed as a ro-
bust connecting box in a dripping water-protected housing which can be used
outdoors. Glands for the sensor cables at the bottom of the housing allow easy
installation.
CE-Declaration of conformity
The product complies with the relevant directives and is there-
fore labelled with the CE mark. The Declaration of Conformity
is available upon request, please contact RESOL.
EN