FAR SO&LEO CI Manual De Utilización página 61

English
Press the on/off switch on the appliance to switch it on.
2.
See Fig.4
Adjust the suction power
You can adjust the suction power:
Using the sliding switch on the tube handle.
1.
See Fig.5
Using the variable suction power button on the vacuum cleaner
2.
(only on certain models). See Fig.6
Emptying the dust cylinder
Empty the dust cylinder when the amount of dust in the cylinder reaches the
MAX level, at the very latest, or when you start to lose suction power.
See Fig.7
Release the dust cylinder, removing it by the handle. See Fig.8
1.
Remove the dust cylinder from the vacuum cleaner towards the back. See Fig.9
2.
To empty the dust cylinder, hold it above a bin. See Fig.10
3.
Press the release button and the bottom will open, allowing the dust to fall into
4.
the bin. See Fig.11
Re-close the bottom of the dust cylinder and then replace it in the
5.
vacuum cleaner. Press firmly on the dust cylinder fittings until it locks
into place. Check that the dust cylinder has been securely fitted into place.
GB-6