Use Of The Equipment With Dmx Controller - Steren PAR-064 Manual De Instrucciones

4.2 Use of the equipment with DMX controller

You can control devices individually using a driver, use a canon cable to
connect the out port INPUT connector of the DMX light controller.
Several apparatuses can be connected together. Only rember to set an available
direction for each lamp.
You can interconnect multiple devices; the Master device controlled the Slave devices in
sync. Never use a "Y" connector to make a split connection.
Do not connect the device to the mains through a dimmer.
10
Male
(output)
You must select the d001 operation mode on the
main lamp using the UP and DOWN buttons then
select a starting direction on the DMX channel using
the INC (increase) and DEC decrease) buttons. If, for
example, setting 17 of the controller is preset as the
operating mode, select setting 17 on the lamp.
Female Male
(input) (output)
CANNON CABLE