Lorex LW1740 Serie Guia De Inicio Rapido

lorextechnology.com/support
ADD-ON CAMERA
LW1741AC1
QUICK START GUIDE
What's Included
x1 x3 x1
Camera Setup
Before installing the camera, carefully plan where and
how it will be positioned, and where you will route the
cable that connects the camera to the power adapter.
Installation Tips
• Camera is rated for indoor/outdoor installation, but is not intended
for direct exposure to rain or snow. For outdoor applications, install
under shelter protected from the elements.
• Wireless cameras require a power source to operate.
• Ensure power outlets are sheltered from the elements.
Use the included mounting screws to attach the
1
camera stand to the mounting surface:
a. Mark the positions of the screw holes on the mounting surface with
the base of the mounting stand.
b. Drill holes and insert the drywall anchors (included) as needed.
c. Firmly attach camera stand to the surface using the included screws.
NOTE: If you run the power cable through the mounting surface,
connect power before attaching the camera to the wall.
2
Attach the camera stand to the camera.
Loosen the adjustment ring
Adjustment ring
3
on the metal camera stand
and move the camera to the
desired position.
Tighten the adjustment ring
when finished, holding the
camera firmly in position.
Connect one end of the camera's power adapter to
4
the camera and the other end to an electrical outlet.
Make sure the power connector is fully inserted to
avoid water getting in the plug.
Remove the protective film from the front of the
5
camera. If the film is not removed, it will affect
picture quality.
www.lorextechnology.com
Pairing the Camera with the Receiver
Connect the new camera
1
to a power outlet. Place the
1ft
camera within 1ft of the
wireless receiver.
2
Press on the receiver to enter the main menu.
3
Select Camera Setting and press
OK to confirm.
4
Select Pairing and press
confirm.
5
Use the arrow keys on the receiver to
select the channel you want to pair
OK
the camera to. Press
desired channel to begin pairing.
NOTE: If you pair a new camera to a channel that is already being
used by an existing camera, the new camera will be connected to
that channel. The old camera will automatically be disconnected.
Following the on-screen prompt,
6
you have 30 seconds to press
the Pair button on the camera.
If pairing was successful, the pairing Pair
channel shows the statement PAIR OK.
Press repeatedly to return to live view to see the camera's video
feed displayed on-screen.
OK
NOTE: If you do not press the Pair button on the camera during
the 30 second pairing window, repeat steps 2~6 to try the pairing
process again.
NOTE: If the speaker begins squealing, move the camera and
receiver away from each other.
LW1741AC1_QSG_TRILINGUAL_R1
OK
OK
to
on the
Pair
Page 1