Packing Content; Product Description - Blumfeldt 10029238 Manual De Instrucciones

Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care
of the following hints to avoid damages. Any failure caused by ignoring the mentioned items
and cautions mentioned in the instruction manual are not covered by our warranty and any
liability.
1 x watering timer unit (pump included)
1 x 10 metre length of vinyl tubing
10 stainless steel spring pegs
1 LCD display
2 Buzzer
3 Connector slot
4 Down button
5 Up button
6 Test button
7 Set button
8 Power button
This special watering kit contains everything you need to water up to 10 potted plants automatically.
The kit contains 10 metres of vinyl tubing, that can be cut to the desired length, and timer that can
be adjusted to alter the frequency and length of time plants are watered for.
Important Notes
• The unit will not function, unless the detector unit on the bottom of the pole is fully immersed in
water.
• If the unit beeps, you need to replace the batteries, or add more water to the bucket. To switch off
the warning sound, press the "power" button for 3 seconds to switch the unit off and then press
the "power" button for 3 seconds to switch the unit back on.
• Before use, consult the reference table at the back of these instructions to determine how many
tubes, and the correctly sized pot/pots that you will need.
• Make sure that any unused connector slots are closed with the caps.
• Normally only one tube is required per plant.

Packing Content

Product Description

Hints and Instructions
6