Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. Close the lid and press down gently until it clicks into position to ensure it is
fully closed. Otherwise the kettle may not turn OFF after boiling.
CAUTION: To avoid the risk of splashing while pouring hot water, make sure
the lid is securely closed onto the kettle before operation.
5. Place the kettle on the power base, taking care not to spill any water.
6. Plug the power cord into a 120V AC electrical outlet. Press the ON/OFF
switch down to the ON position. The lighted button will illuminate. Water
will begin heating immediately.
7. When a rolling boil is reached, the lighted button will then turn off; the ON/
OFF switch will lift (up) automatically and the kettle will turn OFF.
NOTE: The kettle can be turned OFF any time during the heating process by
lifting the ON/OFF switch up.
WARNING: This appliance generates heat and escaping steam during use.
Proper precautions must be taken to prevent the risk of burns, fires, or other
injury to persons or damage to property. Keep hands and face clear of the
area above the kettle.
8. Grasp the handle and carefully lift the kettle from the power base before
pouring.
CAUTION: Always check that the ON/OFF switch is in the OFF (up) position
before removing it from the power base.
CAUTION: To avoid a risk of splashing, make sure the lid is securely closed
onto the kettle before operating. Pour slowly and be careful not over-tilt
the kettle.
CAUTION: Do not touch hot surfaces!
9. To reheat, check the water level to ensure it is above the MIN water level. If
necessary, add more water before returning the kettle to the power base.
10. Allow at least 30 seconds before pressing the ON/OFF switch down to the
ON position.
11. When not in use unplug the power cord from the wall outlet. Allow the
unit to cool completely before cleaning. Empty the kettle after each use.
Do not allow water to sit in the kettle overnight. See User Maintenance
Instructions.
Boil Dry Protection
A safety thermostat will automatically turn the kettle OFF whenever the unit is
without sufficient water, or if the kettle is allowed to boil dry. To reset the boil-
dry protection device, remove the kettle from the power base and allow it to
cool before refilling with water.
User Maintenance Instructions
This appliance requires little maintenance. It contains no user serviceable
parts. Do not try to repair it yourself. Any servicing requiring disassembly must
be performed by a qualified appliance repair technician.
Care & Cleaning Instructions
CAUTION: Always unplug kettle and allow to cool before cleaning.
Never immerse kettle, power base, cord, or plug in water or other
liquids. Never use scouring pads or harsh cleansers to clean your
086_KS Plastic 1.7L kettle R1.indd 7
2019-11-12 2:45 P
Publicidad
Tabla de contenido
