Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Parking Foot (Figure 13)
Your planer is equipped with a parking foot (P) that
automatically lowers into place when the tool is lifted
from the work surface. When planing, the parking foot
raises as the tool is pushed forward. When the
parking foot is lowered, the planer can set on the work
surface without the blade touching.
CAUTION: Do not lock the trigger switch on and engage the parking foot. The
vibration of the running motor will cause the planer to move, possibly falling from the work
piece.
Edge Chamfering (Figure 14)
Your planer has three precision machined chamfering
grooves 1.5mm, 2.0mm and 2.5mm (Q). They are
located in the front shoe and are used for planing
along a corner of the material (figure 14).
a. Adjust to desired depth of cut.
b. Place groove (Q) over edge of material.
c. Apply weight to front of shoe so groove is flat on
material edge.
d. Hold tool with both hands keeping pressure on
front handle.
Note: Itʼs a good idea to try a piece of scrap wood
before doing finish work.
Drive Belt (Figure 15)
WARNING: Turn off and unplug the tool before making any adjustments or
removing or installing accessories.
To Replace Belt
a. Loosen the three screws shown in figure 15
and remove the belt cover.
b. Remove old belt.
c. Place new belt over front pulley then rotate belt
clockwise while pushing belt onto back pulley.
d. Attach belt cover and securely tighten screws.
Maintenance
Cleaning
WARNING: Turn off and unplug unit before cleaning chip discharge chute.
Clean the chip discharge chute (F) regularly. ALWAYS WEAR SAFETY GLASSES.
CAUTION: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
13
14
15
9
P
Q
Publicidad
Tabla de contenido
