Grill Master 720-0894A Manual De Instrucciones página 17

4. Front Panel Assembly
a) Loosen, but do not remove the screws which are
pre-assembled on the cart legs, align the holes on
the front panel (U) with the screw in the legs, then
place the front panel (U) onto the screws in the cart
legs. As shown in Fig. 11.
b) Tighten the screws that were loosened in step 4a.
Note: Flat side of the front panel (U) should face out.
5. Wheel Assembly
a) Place the wheels (V) on the axle which stable in the Cart Leg,
Front Right (F) and Cart Leg, Back Right (G)
b) Place two 5/16" nuts (DD) and two 5/16" flat washers (EE)
which in the hardware pack to the axle and tighten the nuts.
As shown in Fig. 12.
Fig. 11.
U
F
V
Fig. 12.
G
17