Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly for APRILIA RSV4 2009 number plate
ATTENTION :
Before proceeding you must be sure that the motorbike is turned off,
in neutral gear, on a stable position and that no part has any high
temperature.
To assembly it must be a specialized technician. Lightech srl will not
be responsible to any damages caused by a wrong assembly.
ASSEMBLY INSTRUCTIONS:
1. Remove the original number plate support.
2. Assembly the supports (right and left supplied) with the number
plate using the M8 screws supplied (A).
3. Put the assembled supports (Point 2) under the rear light and fix
all together with the M8x20 screw (B) supplied, putting the
bush diameter 15 (C) supplied between the two supports and the
original part under the seat.
4. Position the two original screws and nuts again (D).
5. Put the indicators on their holes (E).
6. Connect all the alimentation cables.
7. Place and fix the number plate support respecting what written
on the sheet given with the package.
Attention: Before riding with the number plate assembled, check
carefully the correct tightening of each screw and nut.
Lightech s.r.l
Via Serenissima 15
31025 S. Lucia di Piave (TV) Italy
Tel +39 0438 453010
Fax +39 0438 655919
info@lightech.it
support
Pg 2/6
Publicidad
