4-Wire Branch Circuit (For Us And Canada); Final Checklist - Foster 7171900 Instrucciones De Installación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
4-Wire Branch Circuit (For Us And
Canada)
Refer to Figure B:
• Disconnect ground from neutral at free end of conduit.
• Connect the green GROUND wire from the oven to the
GROUND wire in the junction box (bare or green colored
wire).
• Connect the red and black leads from the oven to the
corresponding HOT Wires in the junction box.
• Connect the white wire from the oven to the NEUTRAL (gray
or white) wire in the junction box.
• Connect the local codes and power supply codes using a
terminal.
• The terminal uses a thing adapting to the wire of the cord.
UNGROUNDED NEUTRAL
B
Junction box
Red wires
Bare or
green wire
Important: Use twist-on connector
with square-wire spring
Square-wire springa
8
Cable from
power supply
White wires
Black wires
Cable
UL listed conduit
from oven
connector
From power
supply
Or
From the oven

Final Checklist

To prevent improper connections leading to damage of
electrical components and so voiding the warranty, the
following steps must be performed:
1. Check the electrical requirements and make sure you have
the correct electrical supply and that the oven is properly
grounded.
2. Turn on the power supply to the oven.
3. Check power at the junction box wires using a voltmeter
having a range of 0-250V.
If you have installed the oven for use on 240V supply, you
should nd that the voltage reading between the black and
red wires (Line to Line) should be 220V to 240V.
If you have modied the oven(s) for use on 208V, the
voltage reading between the black and red wires should
be 190 to 208V.
4. Set the clock by following these steps:
• Immediately turn [+/-] knob to set hours + [INC] or - [DEC].
• Press [+/-] knob again to change minutes.
• Immediately turn [+/-] knob to set minutes + [INC] or -
[DEC].
• Press [+/-] knob or wait for a few seconds to confirm.
Clock is now set.
5. Test the bake mode by following this step:
• Move cooking mode knob to "BAKE" position.
• Cooling fan and oven lights will turn on, the preheat led
will start to blink.
• A beep is sounded when the oven reaches the preset 350
°F (175 °C) and the preheat light stop to blink.
• Move the knob back to "OFF" position to stop cooking.
6. To check the other oven functions refer to the "Using the
Oven Controls" section of the USER MANUAL.
7. If the oven is working properly, turn o the power supply to
the oven.
8. Place the cover on the junction box and make sure the
cover is securely fastened and turn on the power to the
oven.
Leave these INSTALLATION instructions as well as the
Operating Instructions with the owner.

Publicidad

Tabla de contenido
loading

Tabla de contenido