Extra Functions; Care And Maintenance - Hauck Prema Instrucciones Para El Uso

INSTRUCTIONS FOR ASSEMBLY AND USE
Figures 1
Use a screwdriver (not included) to unscrew both of the screws from the frame (b).
Figures 2-3
Now fasten both of the rear wheels (a) onto the frame, by using a screwdriver to screw in both
of the screws (b).
Figures 4
Push the front wheel unit (e) into the frame (b) from below, in order to mount the front wheel
unit.
Figures 5
Now push the handlebars (f) into the front wheel unit (e) from above.
Figures 6
Put the bolt through the hole to connect the front wheel unit (e) and the handlebar (f) put the
washer and tighten the nut.
Figures 7
Now push the upper sleeve of the handlebars (f) onto the front wheel unit (e).
Figures 8
In order to fasten the seat unit (d), unscrew the screw from the seat unit (d) and put the seat
unit onto the frame.
Figures 9
Now screw the seat unit (d) firmly in the position that you desire.
CAUTION: check that the seat unit is seated firmly (d)!
Figures 10-11
Push the backrest unit (g) onto the frame (b), until it engages with a click.
CAUTION: Make sure that it cannot be pulled off!
Figures 12-13
Put the push handle (h) onto the backrest unit (g), until it engages with a click.
CAUTION: Make sure that it cannot be pulled off!
Figures 14
Finally, fasten the transport container (basket) (c) onto the frame (b).
Figures 15
Your Prema tricycle is now in working order.
Figures 16-17
Always fasten the safety belt around your child.

EXTRA FUNCTIONS

Figures 18-19
Pull the star lock out to let the front wheel runs freely (refer to Figures18) and locked the front
handle bar (refer to Figures 19): the pushed handle must be fixed of the seat. The child can
rest his feet on the pendals when the tricycle is being pushed along, without the pendals
turning too. Adult must be there to control the movement and never play it on any dangerous
place (stairs or sloping routes etc..)
Figures 20-21
Clip the star lock in and lock the free front wheel (refer to Figures 20) and unlocked the front
handle bar (refer to Figures 21): the pushed handle must be released from the tricycle. The
child can drive the tricycle himself by pushing the pedals.

CARE AND MAINTENANCE

• Only use this article in dry places. Dry the metal parts of this product with a cloth in order to
protect them from rust, whenever it does become wet at any time despite that.
• Use a dry cloth and mild soapsuds to clean it. Do not use any household cleaners, ammonia or
petroleum spirit.
• Remove any sand or salt from the wheel bearings and wheels in order to prevent squeaking or
corrosion, whenever the product has travelled through sand or salty water .
GB
7