Connections For The 60175 Booster - Marklin Digital 60175 Manual De Instrucciones

Examples for Dividing a Layout up into Power Consumption Areas:
Two halves
Main Line and Switching Operation
Inner Loop and Outer Loop

3 Connections for the 60175 Booster

All transformers and switched mode power packs connected to the layout must be un-
plugged from the household current before connecting the Booster to the layout. Each
Booster and/or each Central Station must be connected to its own switched mode po-
wer pack. The layout itself must be separated into planned power consumption areas.
The different power consumption areas must be separated from each other electrical-
ly. This means that the contact for the center conductor must be isolated in H0 track
at the transition points between power consumption areas. Both of the running rails at
these points must remain connected to produce a "common ground".
Plug the Booster into the Central Station at the socket marked and connect the
Booster to the track with the wire included with it (the Booster) (if you don't use the
wire included with the Booster, then make sure that the wire is no longer than
2.0 meters / 78"!). Make sure when making the connections that the red wire (B) is
connected to the center conductor (B) (The assignments for the wires must be the
same as for the Central Station!).
8