Description Of Operation And Features - Southwire XDTM Instrucciones De Funcionamiento Y Mantenimiento

DESCRIPTION OF OPERATION AND FEATURES

CAUTION
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH.
CAUTION
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH
Description of Operation and Features
Contains FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Contains transmitter module IC: 12246A-MB71S2
CAN ICES-3 (A)/NMB-3(A)
5
DESCRIPTION OF OPERATION AND FEATURES
NOTE:
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own
expense.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Under Industry Canada regulations, this radio trans-
mitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p) is not more than
that necessary for successful communication.
Caution:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
RF Exposure:
This equipment complies with radiation exposure limits set forth for
an uncontrolled environment. This equipment is in direct contact with
the body of the user under normal operating conditions. The trans-
mitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
6