Cleaning Instructions - NORTH STATES 8657 Manual De Instrucciones

PET DOOR OPERATION
Your enclosure comes from the factory with the pet
door in the "LOCKED" POSITION (See FIGURE 7).
TO UNLOCK
Squeeze and twist the front center knob located
below the pet door. As you twist, the knob will line
up with the arrows on the right or left sides of the
knob. The pet door will move freely in both
directions for your pet to pass through.
TO LOCK
Squeeze and twist the front center knob located
below the pet door. As you twist, the knob will be in
the upright position, keeping the door securely
locked.
WARNING
!
Make certain that the pet door is securely locked in the
closed position if using with a child 6-24 months of age.
TO DISCONNECT PANELS
To disconnect two adjoining panels, select one of the
joints where the panel pushes down (panel 1), as
shown in FIGURE 8.
Gently press down on panel 1 while lifting slightly on
panel 2. This will enable you to slide pin "C" free of
cylinder "D" (see FIGURE 4). Then lift up on panel 1
until opening "A" (see FIGURE 3) is free of pin "B".
FOLDING FOR TRANSPORT OR STORAGE
Your enclosure folds compactly for transport or storage. You must,
however, fold the panels properly. Disassembly and folding is
accomplished by first following the "DISCONNECT PANELS"
instructions above.
Gently fold the panels (without jerking them or slamming them
together) in alternating directions like an accordion. FIGURE 9
illustrates the configuration of a properly folded yard.
Slip one end of the gray carrying strap through the mesh near the
top middle of each outside panel and snap it closed. The enclosure
is now ready for transport or storage.

CLEANING INSTRUCTIONS

Your enclosure is manufactured from durable, weather-resistant plastic panels. To clean, wash the
panels with mild, non-abrasive detergent, rinse with clean water, and allow to dry thoroughly.
REPLACING A PANEL
A broken panel can easily be replaced by obtaining one from the manufacturer at
http://northstatesind/main/shop-parts/
Remove the broken panel by following the "TO DISCONNECT PANELS" instructions (above).
Install the replacement panel by following the "SET-UP INSTRUCTIONS" (page 3).
FIGURE 7
Locked Position
Squeeze and Twist to Open
FIGURE 8
PANEL 1
FIGURE 9
FIGURE 9
Open Position
(Front View)
Locked Position
(Back View)
D
Pin C
Opening A Pin B
Page 4
PANEL 2