Cleaning Instructions - NORTH STATES 8657 Manual De Instrucciones

PET DOOR OPERATION
Your enclosure comes from the factory with the pet
door in the "LOCKED" POSITION (See FIGURE 7).
TO UNLOCK
Squeeze and twist the front center knob located
below the pet door. As you twist, the knob will line
up with the arrows on the right or left sides of the
knob. The pet door will move freely in both
directions for your pet to pass through.
TO LOCK
Squeeze and twist the front center knob located
below the pet door. As you twist, the knob will be in
the upright position, keeping the door securely
locked.
WARNING
!
Make certain that the pet door is securely locked in the
closed position if using with a child 6-24 months of age.
TO OPEN ENCLOSURE
To disconnect two adjoining panels, select one of the
joints where a dark gray carpet foot is facing up, as
shown in FIGURE 8.
Gently press down on panel 1 while lifting slightly on
panel 2. This will enable you to slide pin "C" free of
cylinder "D" (see figure 6). Then lift up on panel 1 until
opening "A" (see figure 5) is free of pin "B".
FOLDING FOR TRANSPORT OR STORAGE
Your enclosure folds compactly for transport or storage.
You must, however, fold the panels properly. Disassembly and
folding is accomplished by first following the "TO OPEN
ENCLOSURE" instructions above.
Gently fold the panels (without jerking them or slamming them
together) in alternating directions like an accordion as shown in
FIGURE 9.
Slip one end of the gray carrying strap through the mesh near
the top middle of each outside panel and snap it closed.
The enclosure is now ready for transport or storage.

CLEANING INSTRUCTIONS

Your enclosure is manufactured from durable, weather-resistant plastic panels. To clean, wash the
panels with mild, non-abrasive detergent, rinse with clean water, and allow to dry thoroughly.
REPLACING A PANEL
A broken panel can easily be replaced by obtaining one from the manufacturer.
www.northstatesind.com
Remove the broken panel by following the "TO OPEN ENCLOSURE" instructions (above).
Install the replacement panel by following the "SET-UP INSTRUCTIONS" (page 3).
FIGURE 7
Locked Position
Squeeze and Twist to Open
FIGURE 8
PANEL 1
FIGURE 9
FIGURE 9
Page 4
Open Position
(Front View)
Locked Position
(Back View)
Dark Gray
Carpet Foot
PANEL 2