Connecting To The Base Unit Or To Another Computer; Registering The Usb Adaptor - Panasonic KX-THA14 Manual De Instrucciones

Connecting to the Base Unit or to another Computer

Registering the USB
adaptor
Before you use the USB adaptor you must
first register it to the base unit, another
USB adaptor, or another Bluetooth device.
1
Your computer:
Connect the USB adaptor to your
computer.
L The MULTI TALK V USB Utility starts.
If the software does not start, refer to
the troubleshooting section (page
18).
2
Click the Data Link Manager icon in the
MULTI TALK V USB Utility-Main Menu
window.
L Data Link Manager window is open.
3
Click [Find Device].
L All connectable devices are listed in
the Device List.
L A maximum of 10 devices can be
found.
14
For assistance, please visit http://www.panasonic.com/phonehelp
4
Select the device you would like to
connect to, then click [Find Service].
L All available services are listed in the
Service List.
L When you connect to another
computer's USB adaptor or a
Bluetooth device, skip to step 6.
5
Base unit:
Press and hold {INTERCOM} until it
starts flashing and a beep sounds.
L After {INTERCOM} starts flashing,
the rest of the procedure must be
completed within 2 minutes.
6
Your computer:
Select the desired service, then click
[Connect].
7
Enter the device's PIN. (Refer to the
operating instructions provided with the
device.)
L When you access to the base unit or
another USB adaptor, enter the
current 4-digit PIN (default: "7262").
L Depending on the Bluetooth device,
the PIN for the device is not required.
8
Click [OK].
L The animation in the lower left corner
of the Data Link Manager screen
indicates that the connection is
established.
L If you close the Data Link Manager
window, the current connection is
disconnected.
Note:
L The screen shots in these instructions
are for Windows XP and are included for
reference only.
L The screen shots in these instructions
may differ slightly from the screen
shown on your computer.