Publicidad
Idiomas disponibles
Idiomas disponibles
The appliance comes with two trimming combs in different lengths for
trimming hair to a uniform length (e.g. eyebrow shaping):
• short trimming comb (6): 5 mm / 1/5"
• long trimming comb (7): 8 mm / 1/3"
Ensure that the appliance is turned off before attaching a trimming comb.
We recommend that you start with the long trimming comb. Slide it over the
cutting head (2) until it clicks into place.
Turn on the appliance and gently comb your eyebrow against the direction
of hair growth as shown in (b). Ensure that either one of the comb sides is
guided flat against the skin.
Cleaning and maintenance
Always turn off the appliance before cleaning.
Remove the cutting head (2) by turning counterclockwise 90° and then lifting
it up (c).
You can rinse the detached cutting head under warm running water.
A natural soap may also be used, provided it contains no particles or
abrasive substances. Rinse off all foam.
Please ensure that the cutting head is completely dry before attaching it.
For storage, the stand (5) can be used. Attach the protective cap (1) to the
cutting head (2).
We recommend lubricating the blade with a drop of light machine oil twice a
year or after cleaning with water.
Subject to change without notice
At the end of their life, empty batteries and the appliance should not be
thrown away with general waste or rubbish. Please dispose of them
according to national or local regulations.
4
Publicidad
