Air Filter; Oil Change - Bohmer-AG i Serie Operación Manual

i Series

Air filter

The air filter is installed on the intake system of the engine. It allows clean air to flow into the engine to
provide the correct air/fuel mixture.
To check/clean
1. Open generator side panel
2. Check air filter to ensure it is free of dirt build-up
3. If dirty, remove filter and clean with a solvent cleaning solution
4. Squeeze to remove water and allow to dry
5. Add a few drops of oil
6. Squeeze tight to distribute oil and remove any excess
7. Install air filter and cover

Oil change

1. Access oil filler as per Quick start guide
2. Undo the oil bung
3. There is a lip to the the spout above an opening
in the chassis.
4. Tip the unit forward to allow oil to drain through
the opening.
5. Add new 10W-40 semi synthetic oil to the
upper limit of oil cap
6. Install oil bung
© Böhmer-AG
English
13