Ice making not
available
Compressor doesn't
run or suddenly stops
Warning indicator
lights and alarms
Warning indicator
flashes
Water leaks from
taps or faucet
Water is dripping out
of water dispenser
Noise
CLEANING & MAINTENANCE
General Cleaning
General cleaning should be performed as needed
and only takes five minutes or less.
1.
Clean the cabinet surfaces using a soft cloth and warm, soapy water. Rinse.
2.
Wipe dust in the back of the water cooler to improve efficiency.
3.
Remove drip tray cover and hand wash. Take a cloth and warm,
soapy water to rinse the inside of the drip tray. Rinse.
Ice button and ice
indicator light
Cold water function
functions are running
Main power supply
Ventilation blocked
Clearance around unit
Condenser
Too dirty, overheating
Cooling system
overcharged or leaked
Compressor and
accessories
Water bottle
Ice-making box in the
ice-making chamber
Water faucet button
Water faucet
Water bottle
Water drain cap
on the back
Floor
Ice-making function
is not turned on
the control panel
Both ice-making
and cold water
at same time
Voltage too low
Blocked
Too small of a
clearance, bad
air circulation
Refrigerant
Breakdown
There is no water
The ice-making box
is clogged by ice
or mechanism
Water faucet
button may have
been clogged
Water faucet has
been damaged
customer service to get it replaced
The bottle has
small holes
Loose
Tighten and check sealing silicon
material inside to see if drain cap
is torn or damaged. If so, replace.
Unit is not level
Press the ice-making button
on the control panel
Wait a few minutes or stop
the cold water function
Contact electrician
Remove the blocked substance
Leave 4 inches around unit
Clean
Contact qualified
serviceman to repair
Contact qualified
serviceman to repair
Replace with a new bottle
Stop the unit and wait for
the clogged ice to melt
Check it and let the button go
Call a qualified serviceman or
Replace bottle
Make sure unit is on even floor
10