Helpful Tips - Igloo IWCTLICM353CRHBKS Instrucciones Y Recetas

4. The ice maker automatically stops working when the unit has detected full of the ice
inside. At same time the ice-maker indicator will change from blinking to illuminating.
5. Ensure to keep a reasonable hygiene level in the water tank of the ice
maker. If unit isn't in use for a long time, take down the water bottle and
drain out all water from both drain port at the back of the unit.
HOW TO GET THE ICE
• Open the ice getting entrance door and use the ice scoop that is included to scoop the ice.
NOTE: When you turn on the cold water operation and ice making operation at same
time, wait a few minutes to let the water temperature in the cold tank go down. It
will sthen switch to the ice-making operation. If the cold water temperature goes
up again or you drink the cold water from the cold water faucet, the unit will switch
to Cold Water operation again after the present ice making cycle finished.
REPLACING AN EMPTY BOTTLE
Replace the bottle as soon as you notice that it is empty.
1. Lift the bottle straight up to disengage it from the bottle probe.
2. Remove the tamper seal from the bottle cap of the NEW
bottle. DO NOT remove the plastic cap.
3. Lift the bottle and insert it (assembly directions above). Apply slight pressure
until the plug inside the cap pushes in and the bottle is secure.

HELPFUL TIPS

PROBLEM
Hot and cold water,
ice-maker are all not
available, and the
power indicator
light isn't on
Hot water anot
available
Cold water not
available
9
CHECK
Main power supply
switch in your house
Power plug
Circuit breaker
Hot water button and
hot water indicator
Cold water button and
cold water indicator
Air clearance between
unit and wall
Water bottle
Ice-making
PROBABLE CAUSE
At "OFF" position
Not plugged in
Tripped
Hot water function
is not turned on
Cold water function
is not turned on
Ventilation around
unit is insufficient
The temperature is Put the water in a shady, cool place
too high (exposed
to sunlight)
Both ice-making
and cold water
function are running
at same time
SOLUTION
Move to "ON" position
Plug it in
Check and reclose
Press the hot water button
on control panel
Press the cold water button
on control panel
Space the unit from the wall
by at least four inches
that isn't exposed to sunlight
Wait a few minutes or stop
ice-making function