Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS
Make all initial connections with the power switches OFF on all equipments. Make sure volume level
are all the way down, you can adjust it later.
1. Connect the polarized cable to electric current, then plug to the speaker.
2. Connect a microphone into MIC IN input through a 6.3mm or cannon connector.
3. Use RCA connectors (Line IN) to plug a CD, ipod, MP3 or DVD player, among others.
4. Turn the devices on, a green LED will light on, indicating the equipment is in use.
5. Set the volume level on each device. Adjust the volume control on the speaker.
PLACEMENT
The powered speaker is designed to sit on the floor, a tabletop, or to fit on a standard tripod speaker
stand.
Some recommendations are:
- Avoid placing the speaker in the corner of a room. This increases the low frequency output and can
cause the sound to be muddy and indistinct.
- Avoid placing the speaker against a wall. This, too, increases the low frequency output, though
not as much as corner placement. However, if you do need to reinforce the low frequencies, this is
a good way to do it.
7
Publicidad
Tabla de contenido
