Adding A Camera To The Baby Monitor; Placing The Camera (Wall Mount & Corner Mount) - eufy Security SpaceView Guia De Inicio Rapido

The new baby monitor and camera will set up
automatically. You are all set to use the products after
monitor and camera are charged.
ADDING A CAMERA TO THE BABY
MONITOR
The baby camera and baby monitor are paired out of
the box. Refer to the following steps when adding extra
baby cameras or after resetting a baby camera.
Make sure the baby monitor's version is the same as
the baby camera's.
1. Enter menu settings, go to Camera -> Add Camera, then
follow onscreen instructions to start the pairing.
2. Press and hold the pairing button on the rear of the camera
for 1 second until a notification prompt is heard.
05 English
When more than 2 cameras are added, you can manually switch
among cameras.
Press the OK button, the screen will be switched to the next
camera's screen. The icon of the camera you select will appear.
You can also select the "Cycle Camera" option. The screen
cycles through the list of connected baby cameras according to
preset intervals.
When the volume is set to high, monitor will emit
a loud noise if placed close to the camera. This is a
normal phenomenon and can be resolved when camera
is moved away from the monitor.
PLACING THE CAMERA (WALL
MOUNT & CORNER MOUNT)
1. Use the monitor to test the viewing angle from your desired
mounting spot.
2. Mark the screw holes with a pencil.
3. Drill 1/5" holes into the wall and then insert the anchors
into the holes.
4. Insert the screws through the mounting holes of the wall
mount and screw into the anchors.
English 06