Operation; Important Instructions; Protective Eyewear - Boso Bosch+Sohn bosotherm 5100 Instrucciones Para El Uso

5. Operation

1 Switching on the lamp
 To connect to the mains, fully insert the plug into the socket. Once inserted, the „5 min" LED will
flash. This is the readiness indicator (standby). Press the On/Off button (4) once to switch on the lamp.
2 Enjoying the light
The recommended duration of treatment is maximum 15 minutes and should be limited to a ma-
ximum of two treatments a day. We recommend selecting a shorter radiation period to start with.
However, the skin of some people may show an over-sensitive (e.g. with extreme redness, blistering,
itching, heavy sweating) or allergic reaction to heat radiation, even when the lamp is used correctly.
3 LED display/timer
The infrared lamp indicates your current treatment time with the aid of 3 LEDs.
The treatment time can be set at the following 3 levels.
To scroll through the timer, hold down the On/Off button (4) until the required timer level lights up.
The levels are as follows:
Treatment time
5 minutes
10 minutes
15 minutes
The lamp switches off automatically once the set treatment time has elapsed. To switch off the lamp
manually, repeatedly press the On/Off button (4) until only the „5 min" LED is flashing, the other LEDs
are off and the lamp goes out.
4

Important instructions

The distance between the infrared lamp and the radiated part of the body should not be less than the
following: at least 32 in (80 cm).
Always use the protective eyewear supplied during usage. The protective eyewear corresponds to the
requirements of EN 171:2002 and serves to protect the eyes.
CAUTION: Never look directly into the infrared light without protective eyewear.
Basically,
examine the radiated section of the body regularly. Discontinue radiation immediately if any signs of
an over-sensitive or allergic reaction appear and consult a physician.
5 Switching off the lamp
CAUTION!
The lamp is hot after being used. Let the lamp cool off first long enough before you put it away and/
or pack it up!
Please note that the mains cable must not be wound round the infrared lamp either for storage or
when in use.
Disconnect the mains plug from the socket to fully switch off the device.

6. Protective eyewear

The product complies with the PPE regulation (EU) 2016/425 (reference: OJ L 81, 31/03/2016, p. 51-98), the har-
monised standard EN 166:2001 (reference: OJ C 209, 15/06/2018, p. 18) and the standard EN 171:2002.
Warnings and safety notes
Read these instructions for use carefully! Non-observance of the following information may result in personal
injury or material damage. Store these instructions for use and make them accessible to other users. Make sure
you include these instructions for use when handing over the product to third parties.
WARNING
• Keep packaging material away from children. There is the risk of suffocation.
• Children must not play with the protective eyewear.
• Before using the protective eyewear, check it for signs of external damage (e.g. cracks or holes). If the protec-
tive eyewear is damaged, you must NOT continue using it.
Number of lit LEDs
1
2
3
12