Steren CAL-150 Instructivo De Uso página 153

Press this button followed by the
mode in order to specify the octal calculation mode.
When you press this button after pressing the
the values entered afterwards will be octal values.
Reciprocal / Factor
Press this button after introducing a value in order to obtain
the reciprocal
When you press this button after pressing the
you will obtain the factor of a value that was previously en-
tered.
Press this button in Base-N mode in order to introduce A
(1010) of a hexadecimal value.
Degrees / minute / seconds (decimal – sexadecimal)
Press this button in order to introduce a sexadecimal value
(degrees / minutes / seconds or hours / minutes / seconds).
When you press this button after pressing the
a value in decimal display can be displayed in degrees /
button in Base-N
button,
button,
button,